An hour ago, I had an important meeting and the power lines were cut so I used the UPS to attend the meeting (the UPS can run my PC at full load for half an hour).
I turned on power saver mode so that it doesn't shut off in between, but as soon as I clicked it, the screen freezed, completely. Then I pressed the reset button and it restarted and then had a boot loop. The windows wasn't booting and was stuck on the loading logo.
I attached my windows USB and used a restore point that I made yesterday and the PC booted successfully.
I tried turning the power saver mode on again, and the same thing happened.
Why is this happening? Why doesn't Microsoft Fix this problem?
My windows is fully updated.
I keep the power mode on high performance all the time.
My specs:
Zebronics H61
Core i5 3470
12 GB RAM 1600 MHZ
GT 1030 EXOC GALAX
Cooler Master 450 watt MWE Bronze V2
I turned on power saver mode so that it doesn't shut off in between, but as soon as I clicked it, the screen freezed, completely. Then I pressed the reset button and it restarted and then had a boot loop. The windows wasn't booting and was stuck on the loading logo.
I attached my windows USB and used a restore point that I made yesterday and the PC booted successfully.
I tried turning the power saver mode on again, and the same thing happened.
Why is this happening? Why doesn't Microsoft Fix this problem?
My windows is fully updated.
I keep the power mode on high performance all the time.
My specs:
Zebronics H61
Core i5 3470
12 GB RAM 1600 MHZ
GT 1030 EXOC GALAX
Cooler Master 450 watt MWE Bronze V2