[SOLVED] pc does not want to use all 3600mhz on ram

Jesse.m.niemi

Honorable
Oct 4, 2018
54
2
10,535
basically since i upgraded from 16 gigs of ram to 32 gigs and a higher speed my pc refuses to use 3600mzh and caps at 2400mzh/1200mzh per stick. i tried to change it from bios but it just makes me unable to boot and forces me into safe mode. any way i can fix this?
motherboard is asus prime b450m and ram is kingston renegade 32gb 3600mzh.
Thank you
 
Solution
Overclock manually.
Set DDR voltage 1.35V,
Command Rate 1T,
Latencies 16-20-20-39

Set DDR frequency 2400Mhz and test. This should work fine.
Then increase frequency step by step and test again after each step - 2600, 2800, 2933, 3000, 3200, 3400, 3600.
When test fails, then return to previous settings, that worked.
Overclock manually.
Set DDR voltage 1.35V,
Command Rate 1T,
Latencies 16-20-20-39

Set DDR frequency 2400Mhz and test. This should work fine.
Then increase frequency step by step and test again after each step - 2600, 2800, 2933, 3000, 3200, 3400, 3600.
When test fails, then return to previous settings, that worked.
 
Solution

Jesse.m.niemi

Honorable
Oct 4, 2018
54
2
10,535
Overclock manually.
Set DDR voltage 1.35V,
Command Rate 1T,
Latencies 16-20-20-39

Set DDR frequency 2400Mhz and test. This should work fine.
Then increase frequency step by step and test again after each step - 2600, 2800, 2933, 3000, 3200, 3400, 3600.
When test fails, then return to previous settings, that worked.
Thank you! it worked well and also found out i didn't have d.o.c.p on so it was capped at 1200 mzh