PC restarting on boot...

[pmadeja]

Hello Guys.

I finally changed old parts in myc pc for new ones, I've changed my PSU, CPU, RAM and MOBO. but I got some problem running my PC.
When I turn on PC it starts , but after several seconds it turn off and start again. Monitor says no signal, there is no beeping too. Don't know where problem is and where to look. Checked new parts with old PSU , same problem so I think it's not PSU fault. I can't check RAM because my old RAM was DDR3.

My new build is:

i7 8700k
z370 extreme4
corsair vengeance 3000mhz cl16 2x8gb
seasonic focus 650w plus gold
+ old ssd and hdd drive + my old gtx 770

Where a problem could be ?


Edit:

http://pl.tinypic.com/r/35lhf7r/9

Maybe is this fault ?
I mean this pins.

 

[rocktalkrock]

Yes, they look like bent pins.

 

[pmadeja]

Any way to fix this ?

Is this possible I did it myself ? I don't remember when I've put cpu if everything was fine. I've placed it carefully.

 

[Shektron]

Any way to fix this ?

Is this possible I did it myself ? I don't remember when I've put cpu if everything was fine. I've placed it carefully.

You can try straightening them - there are some good guides on how to do that on YouTube, but you'll have to be careful because it is easy to make the problem worse. One of the good videos on how to fix the issue - yours isn't half as bad as this guy's, so it shouldn't be difficult:

https://www.youtube.com/watch?v=O10BEZHxYY0

 

[rocktalkrock]

Any way to fix this ?

I can't tell from the photo, but if there are just a few bent pins, try to straighten them. If there are many bent pins, contact ASRock and try to get an RMA for the defective motherboard.

 

[pmadeja]

Less than 10 pins looks bent over. Is it safe to try to straighten them by myself ? I contacted shop where I bought motherboard but I don't think they accept it since it is rather mechanical damage.

 

[rocktalkrock]

Less than 10 pins looks bent over. Is it safe to try to straighten them by myself ? I contacted shop where I bought motherboard but I don't think they accept it since it is rather mechanical damage.

I have straightened pins on a motherboard in the past so it can be fixed. But if not, contact ASRock customers support and explain your problem. My guess is they would offer to RMA the board.

 

[Shektron]

Less than 10 pins looks bent over. Is it safe to try to straighten them by myself ? I contacted shop where I bought motherboard but I don't think they accept it since it is rather mechanical damage.

Yes you can try it, but again, be extremely careful. Always keep a check of where your fingers are, and try to keep them above the motherboard rather than on it.

 

[pmadeja]

On monday guy who knows what he is doing will come and check everything. After that I will think about solution. Thank You for Your answers. have a good weekend.