Question PC Stuck boot.

[Armando970]

Hi guys,

My PC can't start after I replace my old motherboard.

It stuck on CPU fan spinning for 10 seconds and shut down and started again and it keeps going.

CPU: i5-2500K
Mobo: GA-Z68AP-D3
RAM: DDR3 HyperX 8GB

I tried all CMOS, reset and stuffs. Nothing seems to be working. I tried taking out the RAM and it beeps like 18 times before shutting down and when I install RAM, it doesn't beep but it shuts down in 10 seconds. and looping.

Does it means, my RAM is broken or something else?

p/s: I know it's old PC, but i'm a student xd

 

[Gerald6049]

Can you tell the detail specs ? What is the old Mboard ?
What is the RAM specs ?

 

[Armando970]

My bad.

Old mobo was AsRock B75M

PSU: SilverStone 80+ plus Bronze SST-ST70E 700WATTS
CPU: i5-2500k (haven't OCed yet)
Mobo: GA-Z68AP-D3
RAM: HyperX Fury DDR3 8GB x2 1600MHz
GPU: RX 470 4GB

 

[Gerald6049]

My bad.

Old mobo was AsRock B75M

PSU: SilverStone 80+ plus Bronze SST-ST70E 700WATTS
CPU: i5-2500k (haven't OCed yet)
Mobo: GA-Z68AP-D3
RAM: HyperX Fury DDR3 8GB x2 1600MHz
GPU: RX 470 4GB

Try to put in the 1-3 (blue) or 2-4 (white) slot. If they still not boot, try each ram in each slot.

 

[Armando970]

Try to put in the 1-3 (blue) or 2-4 (white) slot. If they still not boot, try each ram in each slot.

I tried it. It just on 10 seconds and shutdown then repeat.

 

[Gerald6049]

I tried it. It just on 10 seconds and shutdown then repeat.

Do you have 1333Mhz RAM to try with ? The i5-2500K work on 1333Mhz RAM. Even the RAM 1600Mhz, normally the Mboard will automatically downclock the speed.

But look like this Mboard not doing that, so the systems cant boot.

 

[Armando970]

Do you have 1333Mhz RAM to try with ? The i5-2500K work on 1333Mhz RAM. Even the RAM 1600Mhz, normally the Mboard will automatically downclock the speed.

But look like this Mboard not doing that, so the systems cant boot.

Unfortunately, no, I don't have any other spare 1333MHz other than the 1600MHz :/