Ok so I currently using my spare parts from my PC build to build a PC for my friend but I'm running into a problem that I can't seem to work out. At first my problem was that I was getting the error that system "can not find required map name" I found out that that simply ment that the hdd was not getting power, so I looked and it wasn't plugged in. So I power it off and plug it in but when I go to power it back on, the fans spin for a second and then nothing. So I unplug the hdd and I get the error again. I try plugging in the hdd after the PC was on (bad move) the PC turns off, then turns on and the sata cable heats up and melts so I quickly unplug and power off everything I wait about 5 minutes and make sure everything is working. So with the sata hdd unplugged I once again get the same error.
(Note) the parts are not mounted in a case I have the parts out on my desk and I'm using the screwdriver trick to start it.
I have used two different hdd but I'm met with the same results.
Parts list:
Msi b75a-ie35
i7-2600
×2 4gb 2Rx8 pc3
Radeon rx 480
Corsair cx650m
Any advice is appreciated.
(Note) the parts are not mounted in a case I have the parts out on my desk and I'm using the screwdriver trick to start it.
I have used two different hdd but I'm met with the same results.
Parts list:
Msi b75a-ie35
i7-2600
×2 4gb 2Rx8 pc3
Radeon rx 480
Corsair cx650m
Any advice is appreciated.