[SOLVED] PC wont boot with XMP profile.

[Craig Craig]

So, I'm using this board : MSI Z590-A Pro , pairing it with this memory dual channel kit : Memory Model F4-3600C18D-16GVK
When I enabled the XMP, the system wont boot, It would only boot at default 2133mhz.
I don't know what to do.
Please advise.
Thanks.

 

[Lutfij]

Which two slots are you occupying on the motherboard with the sticks of ram? Are they on slots A2 and B2? Manually input the frequency into BIOS and then if the system boots to GUI successfully, you can input timings and voltage as listed on the sticker on the side of the memory modules.

Just for added measure, make sure you're on the latest BIOS update for the motherboard.

 

[Craig Craig]

Which two slots are you occupying on the motherboard with the sticks of ram? Are they on slots A2 and B2? Manually input the frequency into BIOS and then if the system boots to GUI successfully, you can input timings and voltage as listed on the sticker on the side of the memory modules.

Just for added measure, make sure you're on the latest BIOS update for the motherboard.

Yes, they sits on A2 B2. Only default settings would work. Changing only the frequency wouldn't boot.
And I found similar case on Reddit
It seems to happen on some other Z590 board too.

 

[Nemesia]

Turn on XMP everything at auto and set the speed manually to 3200MHz.

You might not be able to get to 3600MHz using XMP if the RAM is not on the QVL of your motherboard.

Latest BIOS?