I have been using my self-built computer for about a year and suddenly the monitor is showing "there is no signal coming from the computer".
Below are the specs:
-Intel i5-4460
-ASUS H97-Plus
-2x4gb Crucial Baliistix
-EVGA GTX 750Ti SC
-Samsung 840 Evo 250gb
-WD Blue drive 300gb
-Win 7 Home premium
When I connect the DVI cable to the onboard graphics, it boots up fine and displays.
When connected to the card, it beeps once but then no display.
Not sure if I should RMA the graphics card or do clean install of Win7 or upgrade to Win10.
I tried clearing CMOS and disabling the onboard graphics but no dice.
I think I was installing some drivers from SlimDriver and the issue occur. I think the driver was called "PCIe Interface controller". I tried System Restore but did not help.
Now the PC is giving me "1 beep, 3 beeps" at the same time every day even though the system is off and I removed the system speaker.
My SM bus controller is showing "The drivers for this device are not installed. (Code 28)" and
"PCI bus 0, device 31, function 3"
Below are the specs:
-Intel i5-4460
-ASUS H97-Plus
-2x4gb Crucial Baliistix
-EVGA GTX 750Ti SC
-Samsung 840 Evo 250gb
-WD Blue drive 300gb
-Win 7 Home premium
When I connect the DVI cable to the onboard graphics, it boots up fine and displays.
When connected to the card, it beeps once but then no display.
Not sure if I should RMA the graphics card or do clean install of Win7 or upgrade to Win10.
I tried clearing CMOS and disabling the onboard graphics but no dice.
I think I was installing some drivers from SlimDriver and the issue occur. I think the driver was called "PCIe Interface controller". I tried System Restore but did not help.
Now the PC is giving me "1 beep, 3 beeps" at the same time every day even though the system is off and I removed the system speaker.
My SM bus controller is showing "The drivers for this device are not installed. (Code 28)" and
"PCI bus 0, device 31, function 3"