Hi everyone,
A while ago my custom loop spilled water over my WD red 3TB
I ordered a new PCB to try out my luck but unfortunaly upon installing the PCB all i got was some error beeps as if the motor was trying to start up
So i sent the two PCB's to a company in the USA (PCB Solution) to transfer the firmware chip.
Today i received the good PCB again with the transfer completed but still all i get is the same error beeps.
Does anyone have more experience in this or a solution to make the drive accessible again?
without having to spend hundreds of euros?
Thanks in advance
A while ago my custom loop spilled water over my WD red 3TB
I ordered a new PCB to try out my luck but unfortunaly upon installing the PCB all i got was some error beeps as if the motor was trying to start up
So i sent the two PCB's to a company in the USA (PCB Solution) to transfer the firmware chip.
Today i received the good PCB again with the transfer completed but still all i get is the same error beeps.
Does anyone have more experience in this or a solution to make the drive accessible again?
without having to spend hundreds of euros?
Thanks in advance