Question Phanteks P400A offset?

[Assaf Patishi]

Hi everybody,
I just built a new pc using this case. I noticed that the whole motherboard section has a little offset to the right and down.
It is most noticeable when looking at the CPU air cooler.
Is it possible? can someone with the same case confirm this?

 

[Assaf Patishi]

Anyone?
The right word is "tilted". The motherboard looks a little tilted inside the case, just a little bit to the right and down.
The ATX posts were already installed in the case, I just screwed it in..I thought maybe the case itself is a little crooked, at least the posts.

 

[Assaf Patishi]

You can see that the cpu cooler is not sitting flush with the rear fan. And also the memory, gpu.. all seems a little angles (the gpu usually doesn't have sag at all)
What do you guys think?
It looks like this case is not completely straight, at least the part where you screw in the board to.

 

[hang-the-9]

Contact Phanteks support and let them know what you are seeing. You can also remove everything and check on how the motherboard aligns with the case.

 

[popwithNOtart]

did you...install the motherboard correctly? like did you hold it straight so you didnt screw it in tilited

 

[Mr.Frisfruit]

Every case comes with extra supports to allow for different support layouts. As hang-the-9 mentioned, you should disassemble the PC and check whether your supports properly align with your mobo's screw holes. Then again, if the mobo isn't seated properly the rear I/O panel also shouldn't fit, you mentioned nothing about this?