[SOLVED] Phanteks P400a

[Carson412]

So I was building my pc using the phanteks P400a case, and when everything was installed and I was plugging everything into my motherboard, I couldn’t find the power led + and - wires. I looked in the manual for the case, and it turns out that the case doesn’t even come with the two wires, but my pc wont turn on without it. Any ideas or does someone know what to do?

 

[scout_03]

check case manual they are both on same cable then look inside case it could be hidden below front panel .

 

[Carson412]

check case manual they are both on same cable then look inside case it could be hidden below front panel .

check case manual they are both on same cable then look inside case it could be hidden below front panel .

I did look in the manual and the wire isn’t listed as even being there. If you want to, just look up the online manual for the case and you can see that it isn’t there. The only ones listed are power sw, reset sw, and HDD led.

 

[Archaic59]

Pretty sure it has a illuminated power button so you don't need it. As long as the power switch wires are connected for the power button there's no reason for it not to turn on unless you connected something wrong.

 

[scout_03]

a picture of the front panel cable and hdd led one is there so carefully check the case could be hidden on top of panel connector of front panel if not take a picture of case front panel and ask phantek for a replacement under warranty http://www.phanteks.com/assets/manuals/PH-EC400ATG.pdf