POWER LINE SETUP need help

[RUI771]

Hi

In my village there is a open network for all residents and need help capture and share internet from a raspberry pi 2(in on the attic) using wireless with the adapter(TP-LINK TL-WN822N) and then use a set of powerlines (netgear) to share internet to my desktop( in my room) .

so far i tried this tutorial the network is detected but it doesnt have internet acess in my desktop.

http://hackhappy.org/uncategorized/how-to-use-a-raspberry-pi-to-create-a-wireless-to-wired-network-bridge/

Open net work- TP LINK ADAPTER --- RASPBERRY PI --- ETHERNET PORT---- POWERLINE---TO--- POWERLINE--- DESKTOP.


http://imgur.com/JOqMGyJ
Anyone can help me?

 

[kanewolf]

You need to isolate where the disconnect is happening. Can you get internet on the PI? Can you connect an ethernet cable to the PI and get internet? Can you ping the PI from your desktop? Does your desktop show the PI as your gateway?

 

[RUI771]

Can you get internet on the PI?
yes, iam connected via wifi to the network with tp link adapter

Can you connect an ethernet cable to the PI and get internet?
i dont have router, i have access to a open network in my village via wifi.

Can you ping the PI from your desktop?

havent tried yet

Does your desktop show the PI as your gateway?
yes

 

[kanewolf]

Can you get internet on the PI?
yes, iam connected via wifi to the network with tp link adapter

Can you connect an ethernet cable to the PI and get internet?
i dont have router, i have access to a open network in my village via wifi.

Can you ping the PI from your desktop?

havent tried yet

Does your desktop show the PI as your gateway?
yes

My question about the ethernet cable, was can you substitute an ethernet cable temporarily and get it to work?

If your computer has the PI as the gateway, then you either set a static IP address or it got DHCP from the PI. If it can DHCP from the PI then it able to connect to it and it is something in the config on the PI that is incorrect.

 

[RUI771]

was can you substitute an ethernet cable temporarily and get it to work?
no, i doesnt work.


If your computer has the PI as the gateway, then you either set a static IP address or it got DHCP from the PI. If it can DHCP from the PI then it able to connect to it and it is something in the config on the PI that is incorrect.

all i did is run the script in the 1º post and the only thing i changed was the wifi ssid"" and wifi password"".