Pr95 Blend Test error @ 2 hrs - Seeking Advice

[Tierce]

Setup: E6750 GO; Gigabyte P35C-DS3R; 2x 1GB Corsair Dominator PC2-6400 CAS4; Western Digital 500gig; EVGA 8800 GT.

Trying to get everything stable at 3.4 GHz. Have the FSB at 425, 8x Multiplier, core voltage up to 3.75 volts, 2.00 Memory Multiplier, 1:1 ratio puts the memory also at 425, 5-5-5-15 timings.

I was able to run Prime 95 Small FFTs for 8 hours with no errors. Now I'm checking everything else. Blend test went for 2 hours and then returned and error. I need some advice on where I should go from here. I've been a bit caught up on my memory voltage. Motherboard, CPU-Z, and Everest are reading 2.13v after I set the BIOS To +0.2v. Was a bit hesitant to set it to 0.3v because I thought the readings might be correct and somehow my MB is over-volting the RAM. I have not adjusted any other voltage settings, wondering if that should be my next step or not (northbridge, etc).

Thanks in advance for any help.

 

[Thanatos421]

I hope you mean 1.375 volts for core.... 3.75 = melted chip

 

[Tierce]

I hope you mean 1.375 volts for core.... 3.75 = melted chip

Yeah it's at 1.375, botched that number typing the thread in.

Still looking for some advice on this. I went ahead and ran Memtest for 2 passes and had zero errors. I then went ahead and upped the northbridge voltage one step to +0.1v. Set Prime95 to run a blend test while I was out watching football today. Came home to see that another problem I've been seeing had re-occurred. Prime95 itself auto-closed and popped the screen to send an error report to microsoft. I've had this happen a couple times before running Blend and Large FFT tests, but never with Small FFT tests.

So going to try to run the tests again when I can be around to watch things more. Still any advice anyone has would be greatly appreciated.