I have three drives,
two SanDisk SSD PLUS 1000GB drives,
and one WDC WD10 1tb HDD.
I formatted the two SSDs, converted them from basic to dynamic, created a volume on one and set it to one 1.9tb striped volume meant for RAID-0.
I set my motherboards sata mode to raid from achi, then set up an array with the two SSDs as RAID-0.
View: https://imgur.com/gallery/SVUySr6
So at this point I’m confused on whether you can install/boot Windows on a 2-combined-in-one RAID-0 dynamic striped drives or not, with a lot of posts saying you can and some posts and articles saying you can’t.
I disconnected the HDD with Windows on it and booted solely the 2 combined SSDs with a usb stick with a windows install on it. It just keep going to ‘automatic repair’ every time I would restart would go into automatic repair. I hooked up my HDD and booted it off the 2 drives again and it worked, I setup windows and windows was on the drives that I set up as raid-0 dynamic striped drives. I checked disk management though and the 2 drives combined as one were reverted back to basic, not dynamically striped, not raid-0.
Can anyone point me in the right direction?
two SanDisk SSD PLUS 1000GB drives,
and one WDC WD10 1tb HDD.
I formatted the two SSDs, converted them from basic to dynamic, created a volume on one and set it to one 1.9tb striped volume meant for RAID-0.
I set my motherboards sata mode to raid from achi, then set up an array with the two SSDs as RAID-0.
View: https://imgur.com/gallery/SVUySr6
So at this point I’m confused on whether you can install/boot Windows on a 2-combined-in-one RAID-0 dynamic striped drives or not, with a lot of posts saying you can and some posts and articles saying you can’t.
I disconnected the HDD with Windows on it and booted solely the 2 combined SSDs with a usb stick with a windows install on it. It just keep going to ‘automatic repair’ every time I would restart would go into automatic repair. I hooked up my HDD and booted it off the 2 drives again and it worked, I setup windows and windows was on the drives that I set up as raid-0 dynamic striped drives. I checked disk management though and the 2 drives combined as one were reverted back to basic, not dynamically striped, not raid-0.
Can anyone point me in the right direction?