Problems with first build

[94toy22re]

Specs
Processor - Ryzen 5 1400 with stock cooler
Motherboard - GIGABYTE GA-AB350-GAMING 3 (rev. 1.0)
Memory - Corsair Vengeance LPX 16GB (2x8GB) DDR4 DRAM 3000MHz C15
GPU - EVGA GeForce GTX 1050 Ti SSC GAMING ACX 3.0, 4GB GDDR5
Power Supply -EVGA 100-B1-0600-KR 80 PLUS Bronze 600W
HD - Samsung 850 EVO - 250 GB

So this is my first build, assembled everything last night no issues until i started to boot up. I have no signal to the monitor through DVI or HDMI. Also have a red led light on the motherboard saying their is a fault in the cpu. Have gone through the step by step boot problem write up but everything looks fine. Any ideas?

 

[alexoiu]

The board might need a BIOS update for supporting the CPU.
You'd need a supported CPU for that.

 

[DRagor]

Ryzen 5 requires BIOS F6 on this motherboard, so this may be your issue. Contact Gigabyte customer support to find out what BIOS version you have on your motherboard.

 

[neblogai]

If it boots up, just no signal- check if you connected the monitor to the graphics card and not the motherboards ports.