Im thinking of drilling a small hole in one of the corners of my old AMD processor, to make it into a keychain. Now my question is what is the best way of removing the pins below? Id like it as smooth as possible, it wouldnt be nice getting scratched, or my pockets ripped y'see .
Should i individually clip each pin using a wire cutter? And im also afraid that if i drilled the corner, that the corner would suddenly break off, any advice with that?
Thanks
Should i individually clip each pin using a wire cutter? And im also afraid that if i drilled the corner, that the corner would suddenly break off, any advice with that?
Thanks