PS3 *Slim* power and eject switch pinout

[ag3ntwilson]

Hiya,

I need some help please from some clever people

I have built an arcade cabinet containing a PS3. I want to extend the power and the eject buttons to the cabinet to 2 pin momentary switches.
The board that contains these switches is the hsw-001. It is a ribbon connected board ,
And ideas guys please . Thank you in advance

 

[NerdyComputerGuy]

Could you elaborate on your problem?
This is so I can help you.

 

[ag3ntwilson]

Apologies, question makes sense now , I have edited.

 

[ag3ntwilson]

Could you elaborate on your problem?
This is so I can help you.

the board in question....

https://www.aliexpress.com/item/1Pcs-Power-Eject-Switch-Board-PCB-Card-HSW-001-CECH-2500-For-Sony-Playstation-3-PS3/32713610370.html

Hiya, sorry , for some reason only half the message posted.

I need some help please from some clever people

I have built an arcade cabinet containing a PS3. I want to extend the power and the eject buttons to the wall of the cabinet to2 2-pin momentary switches. (so i can control the consoles buttons from the outside.
The control board that contains these switches is the hsw-001.
It is a ribbon connected board with 2 membrane mini switches for the eject and power, however they are surface mounted and i cannot access any connections on the switches,
i can attempt to desolder but would rather not.
And ideas guys please . Thank you in advance