QMS Magicolor 2

[Guest]

Archived from groups: comp.periphs.printers (More info?)

Hi folks,

I have a QMS Magicolor 2 color laser, and it has run fine for the past
years and suddenly it gave a "Replace Belt" error. So I did, and put in a
brand new belt, and still it gives the same error and won't print. I have
tried more than one belt, but the error will not go away.

I have heard the censor might be dirty, however, I cannot locate it on the
belt cartridge or the printer itself. Does anyone know where it is?

Thanks,

Er

 

[Guest]

Archived from groups: comp.periphs.printers (More info?)

Have you reset the message in the menu ?
If is a cx/ex you'll find it under operator control/consumables/replaced
item
if its a desklaser press menu until you reach service then press select a
few times until it says service is selected.

There is no sensor te keep track of the opc-belt's life. The only sensor
present is the belt marker sensor located at the left side just above the
black toner cartrige.


Jeff

"Er" <egerrits[remove]@afpollution.com> schreef in bericht
news:cg03s6$74i$1@news.storm.ca...
> Hi folks,
>
> I have a QMS Magicolor 2 color laser, and it has run fine for the past
> years and suddenly it gave a "Replace Belt" error. So I did, and put in a
> brand new belt, and still it gives the same error and won't print. I have
> tried more than one belt, but the error will not go away.
>
> I have heard the censor might be dirty, however, I cannot locate it on the
> belt cartridge or the printer itself. Does anyone know where it is?
>
> Thanks,
>
> Er
>
>

 

[Guest]

Archived from groups: comp.periphs.printers (More info?)

"FutureChild" <future|dot|child|at|wanadoo|dot|nl> wrote in message
news:412436bd$0$42419$18b6e80@news.wanadoo.nl...
> Have you reset the message in the menu ?
> If is a cx/ex you'll find it under operator control/consumables/replaced
> item
> if its a desklaser press menu until you reach service then press select a
> few times until it says service is selected.
>
> There is no sensor te keep track of the opc-belt's life. The only sensor
> present is the belt marker sensor located at the left side just above the
> black toner cartrige.
>
>
> Jeff
>

Thanks Jeff, that did the trick! I thought in this day and age everythig
would be electronically sensored, but hey, I prefer a manual override any
day!

Er