r9 270x compatability

[balli86_19]

my specs are - i5 3570 ,, 4gb ram(1333)..ddr3
500 gb hdd.. msi r9270x 2gb,,,
..psu master cooler 500w..rs 500

Is it bcoz of the psu that iam unable to use my graphic card ..iam using mother boards graphic to run.....when i coonect to graphic card hdmi port monitor is blank, but graphic card fan is on..when i connect to boards graphic port ,,system starts(when r9 270x is disconnected) other wise doesnt loads

 

[gwapito]

did you connect 2 x6pin power connector from psu? what exact model of CM psu you have?

 

[balli86_19]

let me try and explain it again..
my psu has one 6 pin coonector..u(r9 270x has 2 6 pin connector option)using that i wasnt able to start/boot my pc..
then i used extended connector provided by msi (box).. it did start the pc ..just one time..after that i am unable to load/boot my pc......but.without graphics card its loadin/booting(provide i disconnect my graphic card completely)

 

[balli86_19]

i just checked ..
when i use one 6 pin connector on graphic card(r9) ..it runs inside cpu..but it doesnt connects(blank) with monitor ..when i switch to vga on motherboard graphic ..monitor turns on..i have vga..so use dvi d lead connector...
cant figure out exact problem..

 

[Dragos Manea]

So u must use the connector from your psu AND the connector supplied within the box to power up the 270x, u must use both 6 pins connectors at once, u must fill both connectors on the video card.

 

[Dragos Manea]

Look here how it is properly mounted: https://forum-en.msi.com/index.php?topic=173371.0

 

[balli86_19]

Look here how it is properly mounted: https://forum-en.msi.com/index.php?topic=173371.0

I am using both connectors..card runs (as fan starts spinning).. but on monitor it says check cable signal when i use vga to hdmi lead..
when i use vga to dvi connector ..monitor doesnt shows any message just blank...
both leads are new
windows doesnt loads...

 

[Dragos Manea]

Ur card has 2 dvi's one digital and one analog, for vga conector u must use the analog one http://postimg.org/image/fjor45k07/

 

[balli86_19]

Ur card has 2 dvi's one digital and one analog, for vga conector u must use the analog one http://postimg.org/image/fjor45k07/

using dvi i connector still not resolved

 

[balli86_19]

resolved...bios update worked