RAID 0 Array Not Showing Up On Windows 10

[VersaVices]

Hello, I just built a new PC. Currently running:

Mobo: Asus Sabertooth Z97 Mark-1
SSDs: Crucial 250GB (OS drive, non-raid)
x2 Patriot Blaze 120GB SSDs (RAID0 Array)

I switched to RAID in the BIOS to get the Drive Config on the next reboot. I set the 2 correct drives into a raid0 array and switched my PCH storage setting back to AHCI. I was able to get back into Windows but I'm not able to see my RAID0. The whole point of this is to put my games on the RAID0 array while keeping everything important on the non-raid SSD with Windows on it.

Any advice to how I can proceed with this?

Thanks!

 

[popatim]

When you switched out of raid you now no longer have a raid controller hence the system just see's two unformatted drives now.
Use windows to create the raid if this is 8, 8.1 or 10. Otherwise you load the raid drivers now, change back to raid in the bios, and hope the system will still boot.

 

[FireWire2]

You can change those 2x SSD to dynamic drives and create a RAID 0 under Disk Manager..
You can have a cake and eat it too