Question RAID setup stuck and further boot issue ?

Jul 7, 2022
7
0
10
0
After reloading PC almost every time recommended to set RAID mode. I tried to do so. I used EZ tuning wizard to enable RAID mode. But it stuck in the process. So the tick is displayed in front of "Enable RAID mode", then I choose Port SATA, It gives me my SSD as available disk but on this step the NEXT button is not active, I can go back to PORT selection or cancel RAID configuration. Everything else is not accessible. Boot device is not found.

When I restarting PC, RAID configuration appears on the same step, so I cannot roll it back or continue because of inactive NEXT button.

Is it possible to somehow finish RAID set up or cancel it completely so I can boot?
 
Jul 7, 2022
7
0
10
0
Who recommended the RAID?

What specific drives do you have?
And the OS?
When I restarted PC, and before Windows started, I got a message to change to RAID "press F2 to set..." which I've done. Also, I had a problem that time and date is shown incorrectly almost every time after I turn off/on PC. So guess this issue and the recommendation are related to each other.

I have 1 drive: SSD WDS100T2B0A
Windows 10
 

Zerk2012

Titan
Ambassador
When I restart PC before Windows started I've got a message to change to RAID "press F2 to set..." which I've done. Also, I had a problem that time and date is shown incorrectly almost every time after I turn off/on PC. So guess this issue and the recommendation are related to each other.

I have 1 drive: SSD WDS100T2B0A
Windows 10
Replace the battery on the board. ( time and date is shown incorrectly )

You have one drive so no raid.
 
Reactions: Phillip Corcoran

USAFRet

Titan
Moderator
Mar 16, 2013
157,483
12,068
176,090
24,359
When I restart PC before Windows started I've got a message to change to RAID "press F2 to set..." which I've done. Also, I had a problem that time and date is shown incorrectly almost every time after I turn off/on PC. So guess this issue and the recommendation are related to each other.

I have 1 drive: SSD WDS100T2B0A
Windows 10
1 physical drive.
RAID, of any type, is not for you.
 
Jul 7, 2022
7
0
10
0
Ok, I get it. So how can I cancel RAID configuration? Looks like I'm stuck in the middle of the process and cannot finish it or set this back ?
 
Jul 7, 2022
7
0
10
0
  1. System doesn't see disk with boot
  2. So it goes to BIOS, RAID is selected but its setup is not finished and I cannot finish it or cancel it, at least in the UI for RAID setup.
 

ASK THE COMMUNITY