Ram over clock crashing

[alucard785]

ram overclocking keeps bsod when i over clock to full speed i got a rog b450 f gaming mother board and 2x8 Rgb corsiar 300hz ram only running at 1200hz

 

[Supahos]

None of those numbers make any sense slow down and try again

Did you just try to set the speed at 3000? If so that'll almost always not work. You need to enable xmp/docp to set the timings for you as well

 

[alucard785]

None of those numbers make any sense slow down and try again

Did you just try to set the speed at 3000? If so that'll almost always not work. You need to enable xmp/docp to set the timings for you as well

yes i tried to set the speed to 3000.current clockfor my ram is 1062mhz.
i have a ryzen 7 2700x cpu xmp is for intel right? and what should i use to set my speed and timmings

 

[Supahos]

There will be some version of xmp in your bios might be docp or something similar that does the same thing. You can manually adjust both speed and timings if you wish but that's easier.

Additionally try 2933 when you do it usually 3000 straight up is a bit odd

 

[alucard785]

There will be some version of xmp in your bios might be docp or something similar that does the same thing. You can manually adjust both speed and timings if you wish but that's easier.

Additionally try 2933 when you do it usually 3000 straight up is a bit odd

okay so i went and over looked my bios i have a dram timming but nothing to do it by itself. i go to Ai Tweaker on bios and i tryed to set my speed on ram to 2933 and i still crashed i am new to this overcloking stuff and dont compleatly grasp the functions so far if i take my ram off auto i get a crash

 

[Supahos]

Go to advanced settings in bios, then it's usually under ai tweaker. I'm not near my Asus computer to double check exactly which heading from there

 

[Supahos]

https://pcpartpicker.com/forums/topic/300458-how-to-set-xmp-profile-on-asus-b450-f-motherboard-bios

 

[Supahos]

Should be pretty similar to that

 

[alucard785]

Should be pretty similar to that

okay so i set the docp and it set all the trimmings and then on restart i got black bios screen saying memory set to default cause failure to boot

 

[Supahos]

Is there a 2933 setting under docp tab?

 

[alucard785]

Is there a 2933 setting under docp tab?

no it actually set it to 3000 by its self should i retry with the 2933 selected?

 

[Supahos]

Yes, I've seen lots work at 2933 that won't at 3000

 

[alucard785]

Yes, I've seen lots work at 2933 that won't at 3000

you sir a gentlemen and a scholar it passed with the 2933 and is now running at the speed thanks for your patience

 

[Supahos]

Awesome! It usually can be done. Just a matter of not getting too frustrated to fix it