So I finished building my new system yesterday. At first I had the RAM voltage at 1.65V like is specified on my RAM, then it seems like it had trouble recognizing both RAM sticks(not sure if this is because I upped the voltage to 1.65V). After doing the MEM ok thing and stuff it recognized both of my RAM sticks, but I haven't touched the RAM Voltage since. I've left it stay on auto or w/e you call it, it's on 1.50V on now.
Will this cause some problems if I keep it like this? I ran Prime95 yesterday for about 45 minutes, no problems and haven't notice any unstability since yesterday evening. The RAM speed is also @ 1066 instead of 1333 MHZ as suggested on the RAM.
I'm just worried if I go change the RAM voltage and speed that it isn't going to recognize my RAM sticks, is there a problem if I keep it like this.
System Specs:
i5 750 @stock
OCZ LV 2x2GB @1333 mhz 7-7-7-20
Hyper 212 Plus
Corsair 550vx
Asus P7P55D
Radeon HD 5850
Antec 300
Samsung HD 502HJ
Also my CPU temps seem to stay under 40C even under load and about 18-25C idle, is it normal to have them this low? I assume it's because I haven't touched the CPU speed.
Will this cause some problems if I keep it like this? I ran Prime95 yesterday for about 45 minutes, no problems and haven't notice any unstability since yesterday evening. The RAM speed is also @ 1066 instead of 1333 MHZ as suggested on the RAM.
I'm just worried if I go change the RAM voltage and speed that it isn't going to recognize my RAM sticks, is there a problem if I keep it like this.
System Specs:
i5 750 @stock
OCZ LV 2x2GB @1333 mhz 7-7-7-20
Hyper 212 Plus
Corsair 550vx
Asus P7P55D
Radeon HD 5850
Antec 300
Samsung HD 502HJ
Also my CPU temps seem to stay under 40C even under load and about 18-25C idle, is it normal to have them this low? I assume it's because I haven't touched the CPU speed.