Recieving error beeps when trying to start up new build

daskam

Honorable
Jan 9, 2013
3
0
10,510
I have a new build with the following hardware:
ASUS P8 Z77-V LK motherboard
Intel i5-3470 3.2G 6M R
Power supply: Fatality 750W
Memory: Corsair Vengance DDR3 2 x 8GB
Kingston Hyper 120GB SSD
HDD 500GB WD5003AZEX 7K 64M

When starting the computer I recieve one short beep (indicating VGA detected/Quickboot set to disabled/No keyboard detected) then about 5 seconds later I recieve one continuous beep followed by three short beeps (indicating No VGA detected)
I have tried 3 different monitors and cables, and have erased the RTC RAM. All drives seem to spin up and all fans are running when attempting to boot. The green led light on motherboard is also lite.
I am still haveing the same error, what might be the problem? Any advice?
 
I am pretty sure all cables were attached. I tried many times. I do have a freind that has a mobo and will check the RAM. But if the RAM was bad would the drives still spin up?
 
the drives will still spin even with bad memory module. If you have friend that has same socket, try all of your component with it and use your PSU to powering them. Try one component in one time and use your friends components for the other. For example, if you want to test your cpu, use your friend memory. If you want to test your memory, use your friend CPU. Test all of your components, including your SSD and HDD (test if it booting).

If all of that working perfectly, i'm start to suspect your motherboard. Try your mobo with your friends component. Tell the result if you done it