Hi,
So my pc has been working great until this morning. I switched it on and now it won’t post. I have a red DRAM light on my motherboard. All the fans are spinning and the ones with RGB light up.
I have tried...
• Checked all cables
• Clear cmos
• Tried one stick off ram
I upgraded my ram 2 months ago to 2x8GB CorsVengLPX DDR4 3200 (C/CMK16GX4M2Z3200C16). This ram is on my motherboards QVL list but I did have problems when I first installed it. The pc would freeze at the desktop. I had to disable the XMP profile and reduce it down to 3000mhz to stop it doing that. It’s been working fine every since then.
I tried putting my original ram back in this morning (2x4GB CorsVengLPX DDR4 3000) and the same thing happens. Red DRAM light.
Please could someone help with this? I am not sure what else to try. Would it be a safe bet to rule out an issue with the ram itself? Changing from my old to new ram made no difference. Just to add I haven’t done any overclocking and my temps were always below 70 with load. Don’t understand how it can have no problem to this?
Another thing is when I switch on the pc the red DRAM light comes on but it does seem go onto the next check. The light on the motherboard jumps from DRAM to CPU but it goes straight back to DRAM. It’s like it trying to post
Ryzen 5 3600
Gigabyte B450m Aorus Motherboard
2x8GB CorsVengLPX DDR4 3200
GTX 1660 Super
Seasonic Focus Plus Gold 650w
NZXT 510 Elite
Thank you
So my pc has been working great until this morning. I switched it on and now it won’t post. I have a red DRAM light on my motherboard. All the fans are spinning and the ones with RGB light up.
I have tried...
• Checked all cables
• Clear cmos
• Tried one stick off ram
I upgraded my ram 2 months ago to 2x8GB CorsVengLPX DDR4 3200 (C/CMK16GX4M2Z3200C16). This ram is on my motherboards QVL list but I did have problems when I first installed it. The pc would freeze at the desktop. I had to disable the XMP profile and reduce it down to 3000mhz to stop it doing that. It’s been working fine every since then.
I tried putting my original ram back in this morning (2x4GB CorsVengLPX DDR4 3000) and the same thing happens. Red DRAM light.
Please could someone help with this? I am not sure what else to try. Would it be a safe bet to rule out an issue with the ram itself? Changing from my old to new ram made no difference. Just to add I haven’t done any overclocking and my temps were always below 70 with load. Don’t understand how it can have no problem to this?
Another thing is when I switch on the pc the red DRAM light comes on but it does seem go onto the next check. The light on the motherboard jumps from DRAM to CPU but it goes straight back to DRAM. It’s like it trying to post
Ryzen 5 3600
Gigabyte B450m Aorus Motherboard
2x8GB CorsVengLPX DDR4 3200
GTX 1660 Super
Seasonic Focus Plus Gold 650w
NZXT 510 Elite
Thank you