Reflash gpu bios in safe mode

[Eliojr2000]

So I flashed my Nvidia Geforce 210 bios to get higher clocks but i guess i messed up because i cant even boot the pc...

I tried to reflash it on cmd using nvflash on safe mode but it says it cant open the service.

I also tried to run in vga mode/low-resolution, nope..

Also i tried booting to a usb/flash drive with a post i found on this webpage but it said that This program cannot be run in DOS mode

i do not have another gpu, i only have my sister's laptop and a usb. I have the original bios but i cant find a way to reflash it..

PC: lenovo thinkcentre M58

 

[popatim]

You will need a pci gpu at minimum (even an old one will do). Basically you set the bios to initialize the pci card first. then shutdown and install your pcie card as a second gpu. Boot but into dos and flash the pcie gpu. Once the reflash is done its back into the bios to change the PCI back to PEG. then u shut down and remove the pci card.

 

[Eliojr2000]

You will need a pci gpu at minimum (even an old one will do). Basically you set the bios to initialize the pci card first. then shutdown and install your pcie card as a second gpu. Boot but into dos and flash the pcie gpu. Once the reflash is done its back into the bios to change the PCI back to PEG. then u shut down and remove the pci card.

Yes but i do not have another gpu...is there any way to do it by safe mode?

 

[Eliojr2000]

THANK GOD!! I just went to safe mode, disabled the GPU in Device manager, then restarted pc normally..I then reflashed the gpu with the original bios and restarted the computer... TADA!! Working again😀

 

[popatim]

I was thinking it might work also if you had integrated graphics.

Grats anyways!!!