reset meclr instead of cmos on Mobo

[lgunnin]

On a Dell 3010 MB I mistakenly use the wrong jumper to reset the bios: meclr instead of the cmos jumper.
System to boots up, drives light up but with no video so I cannot see what occurs. Usb keyboard functions with light and restarts with ctrl-alt-del. Any advice would be appreciated. lgunnin@yahoo.com

 

[Tradesman1]

Try resetting the CMOS with the correct jumper

 

[lgunnin]

Try resetting the CMOS with the correct jumper

Tradesman1, thank you for responding. I did reset with correct cmos jumper. Since the computer boots w/o post beeps, I assume (but not sure) that I have changer the video setting and am getting no video to the VGA adaptor/monitor (no video card installed). As I said, any advice appreciated, especially as to how to reset or check video output.

 

[Tradesman1]

What mobo/computer, does it have on-board video or is it just a video card

 

[lgunnin]

What mobo/computer, does it have on-board video or is it just a video card

On board video, no card. MOBO is Dell Optiplex 3010 PC System Desktop Motherboard 42P49

 

[Tradesman1]

Is the BIOS screen showing up, if so go into BIOS and see what the primary video is

 

[lgunnin]

Is the BIOS screen showing up, if so go into BIOS and see what the primary video is

Nothing on the monitor at any time, even though the system boots up w/o a beep and light comes on the keyboard. It will reboot when ctrl-alt-del is entered into the keyboard, so I assume that video from the MOBO has been lost without a complaint/beep during boot up.