[SOLVED] rgb fan wiring question - corsair

[Thaerr]

Corsair fans, using Corsair Commander Pro and RGB Node Core:

If I plug fans 1-6 into a commander pro. Must the RGB wires be plugged into the corresponding # on the RGB Node Core?

I'm doing a push/pull setup on the AIO, with the three stock fans being on once side (non-rgb) and three corsair fans on the other that are RGB. My intent is to run all 6 fans through a PWM repeater and then into one slot on the Commander Pro. Then run the 3 RGB fans to the lighting node core in separate slots. I saw a post on a different forum that stated that if you plug a fan into commander pro slot 1, you must plug it's corresponding RGB into slot 1 on the lighting node core. Sounds fishy, so that's why I'm asking.

 

[JohnBonhamsGhost]

Must the RGB wires be plugged into the corresponding # on the RGB Node Core?

no.
the numbers do not need to correspond between the Commander Pro and the Node.

but you should keep them in order by fan model.
1, 2, 3 would be the new RGB fans. 4, 5, 6 would be the stock set. or vice versa.

 

[Thaerr]

no.
the numbers do not need to correspond between the Commander Pro and the Node.

but you should keep them in order by fan model.
1, 2, 3 would be the new RGB fans. 4, 5, 6 would be the stock set. or vice versa.

Thank you!!!