[SOLVED] Ryzen 5 3600 High Temp, what to do?

[Edward1337]

Idle around 50c, in game around 70c.
Should I replace the stock cooler?

 

[norcalsc]

that idle temp seems high, but your temp under load is what you need to keep an eye on. a better cooler would help but isn't absolutely necessary. you are ok to run it the way it is.

 

[Edward1337]

that idle temp seems high, but your temp under load is what you need to keep an eye on. a better cooler would help but isn't absolutely necessary.

I read something about voltage, should i modify?

 

[JerT]

What ive gathered when ive asked around is that its just good to leave anything as stock because the cpu clocks it self and the idle temps vary depending on the monitoring software hwinfo64 and ryzen master seem to be the more accurate ones and the idle voltges for me are 1,375+ and they dip to around 1,300 on heavy load. Idle temps for me 42c lightload 50c-55c extreme load on cinebench 85c-88c and on prime95 75c on avrg.

 

[scout_03]

made sure ou remove the plastic protection under cooler to cpu lso check if it is well seated on cpu and not jiggling specially when fan speed up also name and model of all parts in system with case and fans in for air flow .

 

[norcalsc]

I read something about voltage, should i modify?

not unless you know what you're doing. it really isn't need here

 

[eziokinslayer]

compare with the room temp and check there is enough air flow into ur sys,and check there is enough thermal compound on cpu , voltage change my preference dont do it !
also check there is no unwanted application loading cpu.

 

[NightHawkRMX]

70c is a perfectly normal and safe operating temperature for your CPU.

I see no issues and no need for action.

 

[Edward1337]

Until I buy a cooler, I set the voltage at 1.25, it stays below 50 degrees, around 45c. ( idle )

 

[JerT]

Until I buy a cooler, I set the voltage at 1.25, it stays below 50 degrees, around 45c. ( idle )

Have you tried to run proper stress tests? Like prime95 and cinebench20? Especially if you are manually setting voltages you should to make sure its stable.