[SOLVED] Ryzen 9 5900x Voltage

[CPUscrub]

Ryzen 9 5900x voltage
Hello all
link to bundle
https://www.scan.co.uk/products/3xs-x570-rgb-hardware-bundle-amd-ryzen-9-5900x-asus-strix-x570-f-32g...
system specs
CPU: Ryzen 9 5900X
MOBO: ASUS STRIX X570-F
RAM: 32GB DDR4 corsair vengeance PRO 3200mhz DDR4
GPU: EVGA GTX 1080 Ti waiting on 3080
PSU: ASUS ROG Thor 850W Platinum

Simple question is consistent 1.43v to 1.48v while gaming normal and safe? All voltage controls etc are set to auto D.O.C.P came enabled. Temps are fine low 60 degreed C while at this voltage during gaming can spike to low 70 degrees but only for a couple of seconds. Idle voltage bellow 1.1V with temps in the mid 30s.
Sorry in advance I am a noob just worried as I have read on other forums that CPU voltage shouldn't be above 1.35V.

 

[CountMike]

Ryzen 9 5900x voltage
Hello all
link to bundle
https://www.scan.co.uk/products/3xs-x570-rgb-hardware-bundle-amd-ryzen-9-5900x-asus-strix-x570-f-32g...
system specs
CPU: Ryzen 9 5900X
MOBO: ASUS STRIX X570-F
RAM: 32GB DDR4 corsair vengeance PRO 3200mhz DDR4
GPU: EVGA GTX 1080 Ti waiting on 3080
PSU: ASUS ROG Thor 850W Platinum

Simple question is consistent 1.43v to 1.48v while gaming normal and safe? All voltage controls etc are set to auto D.O.C.P came enabled. Temps are fine low 60 degreed C while at this voltage during gaming can spike to low 70 degrees but only for a couple of seconds. Idle voltage bellow 1.1V with temps in the mid 30s.
Sorry in advance I am a noob just worried as I have read on other forums that CPU voltage shouldn't be above 1.35V.

Try with some (-0.1) negative voltage offset.

 

[CPUscrub]

Try with some (-0.1) negative voltage offset.

thanks get about 1.38V max when it boosts its nocked about 10 degrees C of the temp and it still boosts to 4.8mhz

 

[CountMike]

thanks get about 1.38V max when it boosts its nocked about 10 degrees C of the temp and it still boosts to 4.8mhz

Because of different grades/bins of CPUs, MB manufacturers tend to set a bit higher voltages in default settings and so transfer stability questions to CPU. Obviously some stability is gained but may also be too much for particular processor.

 

[CPUscrub]

Because of different grades/bins of CPUs, MB manufacturers tend to set a bit higher voltages in default settings and so transfer stability questions to CPU. Obviously some stability is gained but may also be too much for particular processor.

Well thanks again should I try to push lower or should I keep it as is?

 

[CountMike]

Well thanks again should I try to push lower or should I keep it as is?

I'm not sure about 5000 series but 3000 was rarely able to go to full 0.1v, mine cant do more than -0.05, Anyway, 1.35 or thereabouts is decent voltage.