- Aug 31, 2024
- 1
- 0
- 10
The event is the following: Yesterday I bought a 480 GB SanDisk Plus SSD, I performed a clean installation of Windows 10 with its corresponding Overprovisioning, I installed the programs and so on, the hard drive works PERFECTLY, except that when opening the crystal disk diagnostic, It only takes 1 hour of use.
In other threads I read that this is because the disks are not continually resetting the chip that counts the hours, but rather they do it every so often. The disk has been on for more or less 6 or 7 hours and it still shows "1 hour", although I have already tried several things such as activating the HIPM and deactivating the DIPM, checking that the firmware is updated, but it still does not respond, In addition, this is an irrelevant detail, because it does not affect memory performance, since the rest of the parameters are completely correct.
If anyone can tell me what causes this I would appreciate it!
Photo:
In other threads I read that this is because the disks are not continually resetting the chip that counts the hours, but rather they do it every so often. The disk has been on for more or less 6 or 7 hours and it still shows "1 hour", although I have already tried several things such as activating the HIPM and deactivating the DIPM, checking that the firmware is updated, but it still does not respond, In addition, this is an irrelevant detail, because it does not affect memory performance, since the rest of the parameters are completely correct.
If anyone can tell me what causes this I would appreciate it!
Photo:
Facebook
Twitter
Instagram