[SOLVED] Should I push pull with different fans?

[maorpes]

Hello everyone. I have the corsair h100iv2 water cooler, and the Silverstone rl06gp pc case.
With the watercooler i got 2×120mm fans with those specs:

Maximum Fan Speed: 2435 rpm
Noise Level: 37.7 dBA
Maximum Airflow: 70.69 CFM
Static pressure: 4.65 mm-H2O

On the rl06 case i got 4×120mm fans with the following specs:

Maximum Fan speed: 1400rpm
Maximum airflow: 53.24 CFM
Static Pressure: 0.91mmH2O
Noise Level: 26.6dBA

Should I do a push-pull configuration of 2 of the silverstone fans pushing through the rad and the corsair fans pulling? Or is it better to only do a push to the rad in front if the case with the corsair fans and put 2 of the rl06 fans at the top of the case as exhaust?

 

[shmoochie]

You could test it, but I don't think the push-pull config will benefit you at all. Unless the rad is super thick, you'll probably only get a couple degree Celsius improvement at most.

 

[maorpes]

You could test it, but I don't think the push-pull config will benefit you at all. Unless the rad is super thick, you'll probably only get a couple degree Celsius improvement at most.

So if I will choose to push-pull it won't be worse than just push because of the difference berween the fans?

 

[CountMike]

Not if you make sure that pull side fans have higher flow rate than push side.