Hi everyone, I need your help on my new setup.
Last week i bought a new system with following components:
newly bought:
AMD Ryzen 7 3800X
AsRock X570m Pro4
450 Watt be quiet! Straight Power 11
1TB AORUS M2 SSD
Corsair vengeance LPX 32GB Kit (2 different kits, later more on that)
recycled: (from my current PC and both still fully functional in this old system)
AMD Radeon RX 570
Samsung SSD 265 GB (which has my win 10 on it)
I assembled everything (mainboard, cpu, 1. ram kit, gpu both SSDs) and started the PC.
Win 10 booted, did some installations and worked afterwards without any problems.
I used the system as normal for a few hours to see if there are some troubles, I also did 2 or 3 restarts to test if it is restarting or if windows wants to install something more.
All of this worked fine, so i started cloning my disk with Macrium refelct from my Samsung SSD to the AORUS SSD.
It started and did at least 50% of the disk, but than the system suddenly switched off. I mean no shutdown or anything, it was just off.
Now I can't even boot into the BIOS. The mainboard has some red POST LEDs. After I switch the system on, the LEDs for CPU and RAM are switched on and switched off after ~3-5 secs again. But after this the boot LED is switched on and stays on.
So I tried the Samsung SSD and the GPU in the old PC and they still worked.
Then I looked at the RAM and found out I bought an Intel specific kit, so I ordered again a Ryzen specific one. But I have still the same behaviour.
Than I tried to minimize the system so it is only mainboard, cpu, one ram and gpu and no SSD.
Even with this I cannot get into the bios.
I also tried:
Any ideas what I could try next?
I could test another psu in case the new one is defect but beside that I'm currently at the end of any ideas.
Regards,
flattervieh
Last week i bought a new system with following components:
newly bought:
AMD Ryzen 7 3800X
AsRock X570m Pro4
450 Watt be quiet! Straight Power 11
1TB AORUS M2 SSD
Corsair vengeance LPX 32GB Kit (2 different kits, later more on that)
recycled: (from my current PC and both still fully functional in this old system)
AMD Radeon RX 570
Samsung SSD 265 GB (which has my win 10 on it)
I assembled everything (mainboard, cpu, 1. ram kit, gpu both SSDs) and started the PC.
Win 10 booted, did some installations and worked afterwards without any problems.
I used the system as normal for a few hours to see if there are some troubles, I also did 2 or 3 restarts to test if it is restarting or if windows wants to install something more.
All of this worked fine, so i started cloning my disk with Macrium refelct from my Samsung SSD to the AORUS SSD.
It started and did at least 50% of the disk, but than the system suddenly switched off. I mean no shutdown or anything, it was just off.
Now I can't even boot into the BIOS. The mainboard has some red POST LEDs. After I switch the system on, the LEDs for CPU and RAM are switched on and switched off after ~3-5 secs again. But after this the boot LED is switched on and stays on.
So I tried the Samsung SSD and the GPU in the old PC and they still worked.
Then I looked at the RAM and found out I bought an Intel specific kit, so I ordered again a Ryzen specific one. But I have still the same behaviour.
Than I tried to minimize the system so it is only mainboard, cpu, one ram and gpu and no SSD.
Even with this I cannot get into the bios.
I also tried:
- reset CMOS -> no change
- remove CMOS battery and wait some time -> no change
- start without ram -> system does restarts every 30 secs as it cannot start without ram
- remove cpu cooler, remove and refit cpu -> no change
Any ideas what I could try next?
I could test another psu in case the new one is defect but beside that I'm currently at the end of any ideas.
Regards,
flattervieh
Last edited: