hi, today i was searching in the bios for overcloking my CPU, i found something called speedstep and i enabled it, so it somehow went from 2.8ghz to 3.8ghz, when i saved, the pc didnt turn on, i restarted the pc, fans worked, no display, no beep when u turn on the pc, and drivers worked.
so i did reset the bios by removing the cmos battery, then when i turned the pc on i recieved a message: "266mhz system bus processor is installed. This processor is not supported on this system board, and will run at reduced processor clock speed. System performance will be impacted.
Do you wish to continue to boot at 38528mhz system bys and reduced processor speed? (Y/N)
Press [Y] to continue or press [N] to shutdown."
so i tried to press Y or N, none of them worked, cuz the whole keyboard was not working, i tried the mouse in the same port, the mouse worked but i couldnt do anything with it.
so now im stuck on this screen. Please, is there a way i can pass this screen?
*please dont ignore this, its really important...
Thank you
so i did reset the bios by removing the cmos battery, then when i turned the pc on i recieved a message: "266mhz system bus processor is installed. This processor is not supported on this system board, and will run at reduced processor clock speed. System performance will be impacted.
Do you wish to continue to boot at 38528mhz system bys and reduced processor speed? (Y/N)
Press [Y] to continue or press [N] to shutdown."
so i tried to press Y or N, none of them worked, cuz the whole keyboard was not working, i tried the mouse in the same port, the mouse worked but i couldnt do anything with it.
so now im stuck on this screen. Please, is there a way i can pass this screen?
*please dont ignore this, its really important...
Thank you
Facebook
Twitter
Instagram