Hey guy's, i am in the middle of working on a project where space and form factor is of the essence (need to make the system as small and as compact as possible).
Here is the scenario, i have 4 Circuit Boards, some have mounting holes & some don't, they are all different dimensions. How would i go about stacking these above each other, also as a side note, the boards are all independent of each other they don't physically connect to each other.
Standoff's would have worked because they can screw into each other, but again because some of the boards don't have holes and are all different sizes they will not work. Some suggested i use wooden dowel with notches cut out and rubber bands but yea, i plan to resell what i am doing and i don't want it to look botched + i doubt the dowels would be secure.
Again just to recap this is a picture of what i am trying to do, the difference being my boards DO NOT! connect into each other like the picture shows, but it gives you an idea.
Picture:
http://www.go-ev.co.uk/projects/batteryCycler/cycler.jpg
TIA - Anton.
Here is the scenario, i have 4 Circuit Boards, some have mounting holes & some don't, they are all different dimensions. How would i go about stacking these above each other, also as a side note, the boards are all independent of each other they don't physically connect to each other.
Standoff's would have worked because they can screw into each other, but again because some of the boards don't have holes and are all different sizes they will not work. Some suggested i use wooden dowel with notches cut out and rubber bands but yea, i plan to resell what i am doing and i don't want it to look botched + i doubt the dowels would be secure.
Again just to recap this is a picture of what i am trying to do, the difference being my boards DO NOT! connect into each other like the picture shows, but it gives you an idea.
Picture:
http://www.go-ev.co.uk/projects/batteryCycler/cycler.jpg
TIA - Anton.