[SOLVED] Stop code Memory Managment

[MotoDude]

So i recently just installed an additional 16 GB of ram to my system bringing my total to 32 GB. its Corsair LPX DDR4 @3200Mhz. Since then i have been getting the dreaded BSOD. It gives me the stop code Memory Management. I did the memory check from thats built into windows and it said there were no errors found. What could it possibly be. I dont know if it matters but I do also run a minecraft server on my pc as well. It has its own 16 GB dedicated to it.

 

[sizzling]

Mixing RAM not from a single kit always carries a risk of issues.

I would try the new RAM on its own. I’d also look at downloading and running MemTest on all the RAM.

 

[onespeedbiker]

Even if you doubled the RAM with the exact same make/model/speed it's likely it's not matched sufficiently and you will get these BSOD. If you continue to have these issues, you will probably need to buy a new 32GB kit of RAM, if you desire the RAM upgrade to 32GB

 

[sizzling]

You could try upping the RAM voltage and/or loosening the timings. That might help stability of mixed kits.

 

[Colif]

The chances of ram working together happily also decreases the more sticks you add. If its 4 x 8gb, its a lottery.

Matched sets are sold like they are for a reason, they know they work together. Or should. No 2 sticks are identical but the sets are pretty close.

Try running memtest86 on each of your ram sticks, one stick at a time, up to 4 passes. Only error count you want is 0, any higher could be cause of the BSOD. Remove/replace ram sticks with errors.