Stuck on "configuring windows features" loop.

Brakkus

Reputable
Apr 14, 2015
47
0
4,530
I'm not sure what to do, every time I restart my computer after the BIOS screen, it goes to a "Configuring Windows Features" screen. It immediately loads to 35% and either gets stuck at 35% (wont go past) or loads up to 100% and then stays there.

I'm going to leave it on over night, but this is driving me insane.

I've tried to system restore to a point before I even said yes to the update (which is why the computer restarted in the first place) but even after a restore to a day ago, it still brings me to this screen. I've tried safemode too, it just brings me to this screen. And it's just bizarre because it's not configuring an update, it's configuring "features"...

Is there any way to fix this? Or will I just have to reinstall windows? :/

Update: After about 45 minutes of configuring features, windows has started. I'm worried about restarting my computer after it doing that so I think I'll leave it on for now. Will update later when I decide to restart computer and the issue persists.

Would delete or close the thread, but don't know how.
 
Solution
Just let it configure, it will eventually finish. It only occurs when you recently installed any window updates to your pc. Once you done that, you won't see it again unless you install another window update in the future.