- Dec 20, 2015
- 2
- 0
- 4,510
I have a Supermicro chassis and motherboard.
I have a Supermicro X10DRi-T motherboard and a 900W Supermicro PSU.
I have put them together, and it successfully powers on (the fans start spinning). However no signal comes out of the VGA port.
I have tried booting with no CPU/swapping between socket #1 and #2, with one RAM module and with none. As soon as I plug a power plug in, the system starts up immediately (I don't even have to press the on button which is weird).
The power button works correctly (if I hold it for 4 seconds, the board and fans power off). It also turns the board back on if I press it afterwards. The UID light also works if I toggle the switch next to the VGA connector. The BMC heartbeat LED is solid after I plug in the power, but after 15 seconds it starts flashing, which I believe is the correct operation.
The speaker produces no beep codes so I am having no success troubleshooting.
I am using one CPU socket, with a Intel Xeon E5-2630 v3. I am also using ECC RAM.
I have a Supermicro X10DRi-T motherboard and a 900W Supermicro PSU.
I have put them together, and it successfully powers on (the fans start spinning). However no signal comes out of the VGA port.
I have tried booting with no CPU/swapping between socket #1 and #2, with one RAM module and with none. As soon as I plug a power plug in, the system starts up immediately (I don't even have to press the on button which is weird).
The power button works correctly (if I hold it for 4 seconds, the board and fans power off). It also turns the board back on if I press it afterwards. The UID light also works if I toggle the switch next to the VGA connector. The BMC heartbeat LED is solid after I plug in the power, but after 15 seconds it starts flashing, which I believe is the correct operation.
The speaker produces no beep codes so I am having no success troubleshooting.
I am using one CPU socket, with a Intel Xeon E5-2630 v3. I am also using ECC RAM.
Facebook
Twitter
Instagram