System Build (Asking For Lookover)

[StalinDaBomb]

This is currently my first build, and I started out on Haswell architecture and am now going through the process of returning motherboard and processor (also PSU) on advice of someone else. This time I am asking before I buy so if you have anything to chip in on what I should or shouldn't do please advise. Two things to mention 1) The keyboard I have selected is an indulgence, it's absurdly expensive but I want to get a high quality keyboard and the RGB gimmic is something I enjoy. 2) I have 6 fans as I am running an N400 case by Coolermaster and I really wanna try and keep some low temps (the case has support for 8 fans and I am already using the two from the case as they are actually high quality). I am open for discussions or an answer if you wish to discuss just put your email in your comment.

You can find my build at this link
http://pcpartpicker.com/p/nQtxwP

 

[Gam3r01]

Drop the PSU down to a 650w unit, no need for that much wattage. (Good choice on the G2 though). if you plan to SLI go for 850.
I would get a single samsung 250GB SSD instead of two smaller ones.
Get the MSI gaming 980Ti, the card you have has the Armor 2X cooler, which is not up to par compared to the Twin Frozr V.

 

[StalinDaBomb]

I had actually intended to run my SSD's in RAID. I had no desire for more space just mirroring through RAID 1.
Also I had been reading online that it is much better for PSU's to run at just about half of their full load, and so I was running under that assumption

 

[Gam3r01]

RAID on SSDs is usually pointless.
As for the PSU, they peak in efficiency between 40-60%, however it is only a few%, and does not impact performance or longevity at all.

 

[StalinDaBomb]

I want to use RAID not for striping but for mirroring. Also ill go change my psu

 

[StalinDaBomb]

EVGA 750W 80+ Gold Certified Fully-Modular ATX Power Supply. How about this psu it has 250w headroom (approximately) and is G2