Hi, everytime I turn on my PC it doesn't show signal to monitor and it reboots like 10-15 times before initiates, and it also resets the BIOS everytime I turn on the PC.
The thing is... after the PC finally decides to start, if I reboot it or shut down to inmendiately turn it on, it works perfectly.
and I think it's the RAM but I'm not sure, I'll try to explain as good as I can.
My actual build is this:
i5-8600K
Gigabyte z390 Gaming X
16GBs de RAM (8x2) DDR4 (CMK16GX4M2D3000C16)
GTX 970 MSI
PSU EVGA 650 BQ
I adquired the new i5/motherboard/PSU/RAM a few weeks ago.
and I had this old config (I got rid of it):
i5-6500
ASUS H170M-Plus
Antec HCG 520w
8GBs DDR4 (4x2) (HX421C14FBK2/8)
When I bought all the new components the RAM arrived first so I decided to use it while I waited for the rest of the components but the PC started to do strange things, when I installed the new ram, everytime I turned on the PC is took like 4-5min to start without signal, then it appeared a message, something like: "Error (A7) Me FW Downgrade", then the PC started normally, I discovered that was the RAM because when I installed back again the old one the PC was just fine.
Then the rest of the budget arrived and I installed all, apparently it was nice so I turned off the PC and went to sleep. The next day when I turned on the PC the problem I did write at the beginning of this post started to happen, I tried to install the old memory to check it but it gives me 4 long beeps and 1 short beep...
I tried to explain it as good as I can, sorry... I hope you guys can help me.
Thanks!
The thing is... after the PC finally decides to start, if I reboot it or shut down to inmendiately turn it on, it works perfectly.
and I think it's the RAM but I'm not sure, I'll try to explain as good as I can.
My actual build is this:
i5-8600K
Gigabyte z390 Gaming X
16GBs de RAM (8x2) DDR4 (CMK16GX4M2D3000C16)
GTX 970 MSI
PSU EVGA 650 BQ
I adquired the new i5/motherboard/PSU/RAM a few weeks ago.
and I had this old config (I got rid of it):
i5-6500
ASUS H170M-Plus
Antec HCG 520w
8GBs DDR4 (4x2) (HX421C14FBK2/8)
When I bought all the new components the RAM arrived first so I decided to use it while I waited for the rest of the components but the PC started to do strange things, when I installed the new ram, everytime I turned on the PC is took like 4-5min to start without signal, then it appeared a message, something like: "Error (A7) Me FW Downgrade", then the PC started normally, I discovered that was the RAM because when I installed back again the old one the PC was just fine.
Then the rest of the budget arrived and I installed all, apparently it was nice so I turned off the PC and went to sleep. The next day when I turned on the PC the problem I did write at the beginning of this post started to happen, I tried to install the old memory to check it but it gives me 4 long beeps and 1 short beep...
I tried to explain it as good as I can, sorry... I hope you guys can help me.
Thanks!