Question This DDR4 won't run at 3200Mhz

[MeistroUK]

It runs fine at 2133mhz but when I enable xmp the pc doesn't boot and have to reset the bios... It's a a520i AC motherboard with 32GB Corsair Vengeance 3200mhz ran dual. Anyone know what can do other than replace the ddr4, I had Kingston Fury beast 16gb dual in before and ran with xmp at 3200mhz

Bios

Bios 2

 

[Fix_that_Glitch]

What cpu?

 

[MeistroUK]

Ryzen 5700G

 

[Roland Of Gilead]

Hey there,

Both your mobo and CPU support speeds up to 3200mhz. I don't see why they won't work. You might try setting the timings and voltage manually.

You can get the correct timings in the 'SPD' tab.

Is your bios up to date? You can check this in the mainboard section of CPU-z and comparing it with the bios numbers available,

 

[MeistroUK]

Hey there,

Both your mobo and CPU support speeds up to 3200mhz. I don't see why they won't work. You might try setting the timings and voltage manually.

You can get the correct timings in the 'SPD' tab.

Is your bios up to date? You can check this in the mainboard section of CPU-z and comparing it with the bios numbers available,

Yep, updated to the f16 bios... Tried enabling xmp but changed the multiplier and boots into windows and shows 2866mhz now

 

[Roland Of Gilead]

Did you clear CMOS after bios update? This would be good to do. It may bring better mem compatibility.

 

[MeistroUK]

I've cleared about 4 times now due to the thing not booting