Question Tt ux200 ARGBs not seamless. pls help

saeedalizaheer

Prominent
Oct 11, 2018
5
0
510
0
Soo I got a new cooler but when I hooked it up and tested the ARGBs through RGBfusion2.0 , I noticed that in the wave patterns,
the wave would start from the bottom, take a whole round(of the ARGB fan), come back at the bottom and disappear at the point from where it started, appear after few moments then repeat the same

I may be wrong but its like as if the motherboard is detecting 16 LEDs on my fan while there are 15 LEDs on my fan so when the software tries to move the wave to 16th led, it doesn't show up on the fan?

also if it is the problem from fan side, I can get it replaced as I didn't use any thermal paste yet (trust me I got a valid reason xd )
 

ASK THE COMMUNITY