Unable to access SSD after using Samsung data migration

[Tcman2000]

So I just tried to clone my HDD to my SSD, I got an error and the program requested that I restart the computer and run check disk. I pressed yes and my computer restarted but now I get an inaccessible boot device error with the BSOD. Is there anyway to fix this or am I screwed? I had already returned the SSD once and they had sent a replacement.
It's a Samsung 850 evo 250 GB

Edit: I used Samsung data migration
I should probably say that the computer runs fine with just the HDD, I only get the error and BSOD when the SSD is plugged in

 

[thx1138v2]

Are you screwed? Maybe. Power down and disconnect the SSD so the machine will boot from the HDD and clean up the HDD so you don't get the error. Then power down and reconnect the SSD being sure to use a higher port number on the mobo than the one the HDD is connected to so the machine will boot from the HDD and try to boot again. If it boots try your cloning software again. If the clone is successful power down, disconnect the HDD and move the SSD a lower numbered port on the mobo than the HDD and see if it will boot from the SSD. If that is good power down and reconnect the HDD to a port numbered higher on the mobo and it should boot from the SSD and your HDD should show up.

 

[Tcman2000]

Would you recommend any methods to effectively clean the HDD?