Unallocated SSD after cloning

[1066060mudkipmi]

After cloning everything on my HDD to my SSD, and restarting my computer, my SSD wasn’t appearing in files(windows 10) and in the disk management it says that the SSD is unallocated

 

[karenjoly]

The problem may simply arise from an inept clone operation.Re clone using Macrium Reflect Free. Here are the steps to follow.
http://knowledgebase.macrium.com/display/KNOW/Cloning+a+disk

 

[1066060mudkipmi]

thats exactly what I did the first time

 

[USAFRet]

Specific steps for a successful clone operation:
-----------------------------
Verify the actual used space on the current drive is significantly below the size of the new SSD
Download and install Macrium Reflect (or Samsung Data Migration, if a Samsung SSD)
Power off
Disconnect ALL drives except the current C and the new SSD
Power up
Run the Macrium Reflect (or Samsung Data Migration)
Select ALL the partitions on the existing C drive
Click the 'Clone' button
Wait until it is done
When it finishes, power off
Disconnect ALL drives except for the new SSD
This is to allow the system to try to boot from ONLY the SSD
Swap the SATA cables around so that the new drive is connected to the same SATA port as the old drive
Power up, and verify the BIOS boot order
If good, continue the power up

It should boot from the new drive, just like the old drive.
Maybe reboot a time or two, just to make sure.

If it works, and it should, all is good.

Later, reconnect the old drive and wipe as necessary.
Delete the 450MB Recovery Partition, here:
https://social.technet.microsoft.com/Forums/windows/en-US/4f1b84ac-b193-40e3-943a-f45d52e23685/cant-delete-extra-healthy-recovery-partitions-and-healthy-efi-system-partition?forum=w8itproinstall
-----------------------------