Herr B

Prominent
May 29, 2020
172
36
690
10
hello there,

I have an ryzen 5950x and wanted to try out ctr 2.0.

Pretty much all I did is pressing the Diagnostic button. Its on the undervolting test now. Diagnostics running over an hour already. Its at set 58 0.845V. Temperature / wattage does not change.

Test is running for over an hour. feels like the voltage is not applied correctly.

This seems odd to me. might be because I set CPU TEL (V) to 1.25 in bios already?

 

keith12

Illustrious
Hey there,

Ideally if you are going to use a program to undervolt, your system should be set at default. So, reset your bios to default. Then use the program and try again.

You can use HWMon/Info to monitor the undervolt and confirm if it's applied or not.
 
Reactions: Herr B

keith12

Illustrious
Hey there,

Ideally if you are going to use a program to undervolt, your system should be set at default. So, reset your bios to default. Then use the program and try again.

You can use HWMon/Info to monitor the undervolt and confirm if it's applied or not.
 
Reactions: Herr B

ASK THE COMMUNITY