upgrading from windows 10 to windows 11 issue

[Mahmoed.ghazy]

RTX3060 12 OC
Ryzen 5 3600xt
Ram corsair vengeance 2x16 3600
B450 Arous elite
700W cooler master
BenQ MOBIUZ EX2510S / 1080P / 165 HZ

I'm trying to upgrade to windows 11 from windows 10. I don't know if i will be able to ? and what do i need to do ?

the issue is from pc health check saying that :

This pc must support secure booting
TPM 2.0 must be supported and enabled on this pc

https://imgur.com/ldjGW9R

View: https://imgur.com/ldjGW9R

 

[jojesa]

RTX3060 12 OC
Ryzen 5 3600xt
Ram corsair vengeance 2x16 3600
B450 Arous elite
700W cooler master
BenQ MOBIUZ EX2510S / 1080P / 165 HZ

I'm trying to upgrade to windows 11 from windows 10. I don't know if i will be able to ? and what do i need to do ?

the issue is from pc health check saying that :

This pc must support secure booting
TPM 2.0 must be supported and enabled on this pc

https://imgur.com/ldjGW9R

View: https://imgur.com/ldjGW9R

Enable both, Secure Boot and fTPM in your BIOS, then your system will be eligible to upgrade to Windows 11.

Secure Boot is available on the BIOS tab, but it might not show if CSM Support is set to Enabled...so you will have to set it to Disabled.

Be aware that if you disk partition is set to MBR, you system might not boot if you enable Secure Boot.
The disk must be converted to GPT, before enabling Secure Boot.

The TPM 2.0 function is integrated in the AMD CPU, but it is disabled by default...it should be located under the Peripherals tab.

 

[Lutfij]

1| Make sure you're on the latest BIOS version for your motherboard.
2| Go into BIOS and enable fTPM, disable CSM and then you should be able to enable secure boot.

 

[Mahmoed.ghazy]

1| Make sure you're on the latest BIOS version for your motherboard.
2| Go into BIOS and enable fTPM, disable CSM and then you should be able to enable secure boot.

easier said than done . I was able to endable fTMP .. restarted pc and then went to bios again to enable secure boot but windows didn't load and kept sending me to the bois section. I tried to reset factory and still did nothing I wasn't able to activate it and go to windows had to disable it and enable cmd

 

[SkyNetRising]

easier said than done . I was able to endable fTMP .. restarted pc and then went to bios again to enable secure boot but windows didn't load and kept sending me to the bois section. I tried to reset factory and still did nothing I wasn't able to activate it and go to windows had to disable it and enable cmd

If windows was installed in legacy mode, then you can't simply disable CSM.
You have to convert OS drive from MBR to GPT using mbr2gpt utility first.

 

[jojesa]

easier said than done .

Sorry, I might have added that warning, on my post, too late.