Im getting desperate at this point. I just bought the IbuyPower Snowblind S case for my build. I simply just needed to migrate my build to the new case. Easy. Tested everything before connecting and trying to power the lcd panel, everything works fine, no issues. Found cables I can use to power the LCD panel, a 6 pin to two molex connectors, and a small cable of female molex connectors. I connected the 6 pin to molex to my PSU, then that to the female cable, finally that to the molex connector on the case. Initially I plugged in both of the splitters from the 6 ping to two female connectors which in turn wouldn't let my system power on. After disconnecting one it powered on, but noticed that I suddenly wasn't getting a display from my 3070ti, I also had a gtx980 plugged in and running so I moved my display cable to that and it was working. I then plugged the HDMI for the LCD panel into my GPU and within 30s it was trying to catch fire, the HDMI cable was. I gave up on getting the side panel running and started working on getting my GPU back up. tried reseating in different slots, tried using a different PSU cable, and re-installed drivers. Then while on a support chat with NVIDIA the GTX 980 suddenly ends up in the same state as the 3070ti. No longer recognized by my motherboard, PCIe slots shows as empty in BIOS, but it does power on with the pc. I have not got to test these cards on other pc's yet, but I am using the system I just described currently, the video card is a spare like office workstation quadro I had. Works fine and took drivers but I can't get my 3070ti or gtx980 to be recognized. More concerned for the 3070ti of course but would like to figure out the problem