Archived from groups: microsoft.public.windowsxp.hardware (
More info?)
Only the ports on the Q-Tec card are USB 2.0, or a port that
is connect to the Q-Tec card. If your front panel ports are
connected to the mobo, the hardware is and always will be
USB 1.1. If this is the case, connect the wires from the
front panel to the Q-Tec card or get a USB 2.0 hub, plug it
in the back and set it up front.
--
The people think the Constitution protects their rights;
But government sees it as an obstacle to be overcome.
"Essexbiker" <Essexbiker@discussions.microsoft.com> wrote in
message
news:2621CEC3-85B0-4152-88A8-B414691C7573@microsoft.com...
| Oh, really?!!! Well, I've uninstalled and reinstalled my
USB2.0 card so many
| times and I DO have the entry that says VIA USB 2.0
Enhanced controller under
| Universal Serial Bus Controllers in my device manager -
but every time I plug
| in my USB external hard drive, it still keeps saying that
I have plugged a
| HIGH-SPEED device into a NON HIGH-SPEED port. I have even
followed
| Microsoft's advice and clicked update driver >
automatically install .....
| but the ports are STILL only working as USB1.1 ports!
|
| I have contacted the card manufacturer (Q-Tec) and
followed all their advice
| to the letter - except that the installation disk didn't
autoplay, which
| meant I had to try and choose which setup/driver to run!
But whatever I do, I
| just cannot seem to get the blessed card working as a USB
2.0 card!
|
| I am now starting to get very frustrated by this and am at
my wits end to
| know what to try next. So if anyone can offer any further
advice, I'd be
| extremely grateful.
|
| "River_Rat" wrote:
|
| > Does it say in one of the ports under USB Controller in
the Device Manager,
| > Enhanced USB if so then it has the 2.0 drivers loaded.
| >
| > Everything that was in SP1 is also in SP2 and a lot
more.
| >
| > --
| > Good Day
| > River_Rat
| >
| >
| >
| >
| > "Mike" <Mikecool90@hotmail.com> wrote in message
| > news:339d01c4a43f$95ea4630$a401280a@phx.gbl...
| > It reloads the 1.1 drivers.
| > >-----Original Message-----
| > >Go to your Device Manager and remove your USB ports
| > listed under USB
| > >controllers and then restart.They will reload at
startup.
| > >
| > >--
| > >Good Day
| > >River_Rat
| > >
| > >
| > >
| > >
| > >"Mike" <Mikecool90@hotmail.com> wrote in message
| > >news:192901c4a430$134e2390$a501280a@phx.gbl...
| > >Asus P5AD2 Premium motherboard.
| > >When I had SP1, everything worked fine. Once SP2 was
| > >installed, all 8 USB 2.0 ports became recognized as 1.1
| > >(no "enhanced"). I tried using a USB 2.0 device, and
sure
| > >enough, it worked at 1.1 speeds...which gets very
| > >irritating when you copy files that are 1GB+. Any help
| > >would be appreciated. Thanks in Advance,
| > >- Mike
| > >
| > >
| > >.
| > >
| >
| >
| >
Facebook
Twitter
Instagram