I've got a little problem here. I just got a SATA hard drive that I want to run as my primary drive and I want to put some partitions and install windows on it. I've also got an older IDE hard drive setup as Primary Master that I would like to setup as extra storage. Whenever I partition, format, and install windows on the SATA drive, it detects the windows partition as G instead of C. I've tried changing this through windows but it will not allow me to change the letter of the one that I am booting from. I basically want to use the SATA drive as my bootable windows drive, and the IDE as spare extra storage. Does anyone have any ideas of the best way I could set this up?