Hi! I have a Abit BE6 board and I used to run a celleron 300 at 464 mhz with voltage at 2.3v. I have since upgraded to a celleron 600 and can get it to run at 749 mhz at 1.7v (83 mhz FSB)
I wish to get my board to go over the 1.7v max that it defaults to with this CPU. I think it should work at 100 mhz FSB if I could get 1.8v as it almost boots up fully before crashing at this speed. I have a peltier and alpha heatsink and heat never gets above 47 degrees C according to the boards sensor. Any ideas? Thanks in advance, pSeUdo.
I wish to get my board to go over the 1.7v max that it defaults to with this CPU. I think it should work at 100 mhz FSB if I could get 1.8v as it almost boots up fully before crashing at this speed. I have a peltier and alpha heatsink and heat never gets above 47 degrees C according to the boards sensor. Any ideas? Thanks in advance, pSeUdo.
Facebook
Twitter
Instagram