i got a replacement for a benq xl2411z that i returned because of annoying backlight bleed along the right side of the screen, i got a replacement and i turned it on, all seemed well, i looked at the edge of the display where the problem used to be only to find some minor bleed but i was not too bothered, i looked at the right side of the monitor and and it is warped the back part of the bezel on the right side of the monitor that attaches to the front part of the bezel is bent outwards at a point only slightly and there is a gap between the two parts of the bezel about 1mm i don't know what to do about this 🙁